The Build-IT FR syringe is a core build-up material for Build-IT FR crowns. The material can be cut like dentin, contains fluorine and has a dual curing mechanism. It is visible on X-rays, which allows you to determine the accuracy of the restoration. It also makes it easier to identify marginal areas. It is suitable for direct application and does not run off, which makes the application easier. The addition of specially prepared glass fibers increases the compressive strength, which reaches extraordinary values of 280 MPa. Build-It FR can be used for all all-ceramic and full-composite restorations. It has many color variants.
Characteristic:
.for core build-up
.contains fluoride
.double curing mechanism
.specially prepared glass fibers increase the compressive strength
.has physical parameters similar to dentin
.easy application
.it is suitable for direct application and does not run off
.dual-curing (light and self-curing) for maximum flexibility
.visible on x-ray pictures
Directions for use:
-Inspect the level of restorative material in adjacent outlets prior to applying the mixing tip.
-if the level in both outlets is not the same, squeeze the excess liquid out of the syringe until substances from both sides flow evenly
-then replace the mixing tip
-do not retract the plunger to stop the flow of material through the mouth of the mixing tip
– this may draw the mixed material into one of the syringe chambers and cause its clogging
instead
– it is recommended to remove and reattach the mixing tip to the syringe
– this will release the overpressure inside the mixing tip and prevent excess material from flowing out
Remarks:
.when using Build-It FR self-mixing syringes, it is important to ensure that the base and catalyst flow evenly out of the syringe – especially important when using the syringe for the first time, as settling during transport can change the level of material in one part of the syringe relative to the other and the base and catalyst will not be mixed in equal proportions, as a result of which the material will not chemically bind
.if you are using a resin-based temporary material (e.g. TempSpan temporary crown and bridge material), an insulating layer must be applied to the Build-It FR restoration material – to prevent adhesion of the temporary material
Build-IT FR is available in a pack containing 8.6 g in 5 shades: A2, A3, Opaceous, White for cosmetic restorations and Gold and Blue for edge definition.
Reviews
There are no reviews yet.